Why there are burrs in the processing of aluminum products

Jun 24, 2020

Leave a message

Why do burrs appear in the processing of aluminum products? The occurrence of burrs has always been a headache for us in the processing of aluminum products. Today, the editor will take you through the reasons for the glitches in order to find a solution.

 

  1. Aluminum products are processed under high temperature and high pressure conditions. The aluminum profile is deformed into a trumpet shape by extrusion, and the cutting edge part is in contact with the profile to form a viscous aluminum profile. The "turning knob" is continuously taken out of the profile and attached to the profile surface. On the formation of a "burr".   

 

     2. If the mold is too shallow, aluminum will gradually increase, and the sticky aluminum gradually brought out by the profile will form "burrs".   

 

     3. The surface and internal impurities of the aluminum profile accumulate in the dead zone of metal flow. In the process of processing, impurities in the dead zone are constantly changing, and some impurities are taken out by the normally flowing metal belt, accumulated in the deformation space of the working belt, and part of the outline is pulled out to form a "burr".