Precautions for aluminum sheet processing

Jan 14, 2020

Leave a message

1. The hardness of aluminum plate.

The aluminum plate is too hard and cracks easily. This requires the selection of aluminum materials, mainly depending on the aluminum material trademark and status. Usually the comparison of 1 series, 3 series, and 5 series is commonly used; the hardness of 6 series and 7 series is too high, it is necessary to perform annealing treatment to the O state before bending. There is also the quality of aluminum plates. Imported materials of the same type of aluminum plates are not simply cracked than domestic materials, but the price of materials is also a lot more expensive.

2. Thickness of aluminum plate.

Too thick aluminum plate is not easy to bend, we understand as soon as we think about it, try to use a thinner aluminum plate.

3. Bend the size of the R angle.

The larger the bend R angle, the higher the success rate, so try to increase the bend R angle as much as possible.

4. Aluminum plate texture direction.

The bending direction should be straight and not parallel to the texture direction of the aluminum plate.

5. For the aluminum plate parts that need to be drawn, in the case of the process, the best is to bend after bending, otherwise the probability of bending cracks will be added.