Pick High Quality Aluminum Sheet

Jan 04, 2020

Leave a message

At present, the domestic aluminum plate industry is booming, there are many aluminum plate manufacturers, and their aluminum plates are also very diverse, but the quality of aluminum plates is also mixed and uneven. How to choose from a dazzling array of dazzling aluminum products with good quality and high cost performance? Here are a few simple steps:

First, look at the outer packaging of the aluminum plate. Good packaging not only shows the strength of aluminum plate manufacturers, willing to spend a lot of money on product packaging, but also shows that manufacturers pay more attention to product protection. In addition, it also shows that the manufacturers have very good management of aluminum sheet production.

Second, look at the surface of the aluminum plate. Good aluminum plate, no surface defects such as roll marks, black spots, scratches, oil spots, corrosion, fission, etc .; flat shape, no obvious bending; single aluminum plate diagonal line is consistent; the entire aluminum plate is neatly placed, each aluminum plate The length and width are consistent. If the surface of the aluminum plate is covered with a protective film, peel off the protective film, and at least look at the entire width of the plate to avoid being covered by defects.

Third, use micrometers, meters, vernier calipers and other measurement tools to measure. According to the requirements, the products provided by the aluminum plate manufacturers are selected for evaluation. According to the magnitude of the measured size, different measuring tools are selected to measure the thickness, width, length, unevenness, diagonal of the aluminum plate and other products. The specific dimensional deviation can refer to GB / T 3880.1-2006. At least three points are selected for each measurement to measure whether the size or error of the aluminum plate is uniform and whether it is within the national standard.

Fourth, aluminum sheet manufacturers are required to provide a bill of materials for aluminum sheets. Good aluminum plate manufacturers will test the composition and performance of each batch of aluminum plates. After the aluminum sheet manufacturer provides the material list, check whether the composition and performance of the product corresponding to the material list are controlled within the national standard range. For specific values, refer to GB / T 3880-2006. And pay attention to the material sheet must be stamped with the official seal of the manufacturer. If there is a problem during the use of the aluminum plate, the aluminum sheet can be tested based on the material sheet, and the quality objection can be raised like the manufacturer.