What is the processing technology of aluminum coil?
Aluminum alloy with a silicon content of 8%-12% is a transitional interval, which can use ordinary cemented carbide and diamond tools. But the use of hard alloy should use PVD (physical coating) method, does not contain aluminum elements, and the film thickness is small. Due to the PVD method and the small film thickness, it is possible for the tool to adhere to a sharper cutting edge (otherwise in order to prevent the film from growing abnormally at the cutting edge, sufficient passivation of the cutting edge is required, and cutting aluminum alloy will not be sharp) , And the film material contains aluminum, which may cause the blade film to interact with the workpiece material and destroy the bond between the film and the tool matrix. Since the super-hard coating is mostly a compound of aluminum, nitrogen, and titanium, it may be chipped due to a small amount of the cemented carbide matrix falling off with the film.
It is recommended to use one of the following three types of tools:
1. Uncoated ultra-fine grain carbide tools
2. Carbide tools with non-aluminum coating (PVD) method, such as TiN, TiC, etc.
3. Use diamond tools
The tool's chip space should be large. It is generally recommended to use 2 teeth, and the rake and clearance angles should be large (such as 12°-14°, including the end tooth clearance angle).
If you only use general face milling, you can use an indexable face milling cutter with an entering angle of 45° and a blade specially processed for aluminum alloy. The effect should be better.
Alumina was also used as aluminum in the laboratory by electrolysis in 1808. It has been used as a building material on the spire of the Washington Monument in the United States in 1884. Aluminum alloy materials composed of various metal elements have been widely used in the construction industry. In all links. The thickness of aluminum alloy sheets: the thickness of high-grade metal roofing (and curtain wall) systems is generally 0.8-1.2mm (while the traditional one is generally ≥2.5mm).
The above is the analysis made by the editor on the processing technology of aluminum coils, mainly the above-mentioned, I hope the analysis by the editor will be helpful to everyone.










