What is aluminum over-tension correction

Nov 21, 2020

Leave a message

What is aluminum over-tension correction

 

After the multi-roll straightening machine straightens the thin plate through this straightening machine, it does not extend itself, but converts the big waves into small waves, making the plate surface almost straight. It is difficult to straighten plates with a thickness of less than 0.8mm. The stretching and bending straightening machine can make the thin plate produce longitudinal and lateral deformation at the same time, thereby fully improving the flatness and material properties of the thin plate, and greatly improving the thin plate straightening technology by one step. In addition, due to the bending stress generated by the bending, the tensile force is greatly reduced. According to experience, when the tensile bending straightening machine is used, to achieve the same straightening effect, only 1/3 of the tension required for pure tensile straightening is required. 1/5. And its straightening effect is by far the best. Stretching and bending straightening are:


1. Good plate shape can be obtained. After straightening by stretching and bending, the wave edge, wave shape, buckling and slight sickle bend of the board can be completely eliminated, thereby greatly improving the flatness of the sheet.


2. It is helpful to improve the anisotropy of materials. The yield limit of deep drawing sheets of mild steel is often anisotropic in the longitudinal and transverse directions. Therefore, when the thin plate is deep-drawn, the thickness of each part of the punched part will be uneven due to the different extension of each part, which will cause the skirt-like lace defect of the punched part, which will lead to an increase in the rate of waste washing. After straightening by stretching and bending, this situation will be greatly improved.