Detailed introduction of aluminum wafer

Sep 25, 2021

Leave a message

Detailed introduction of aluminum wafer

 

 The aluminum discs are cold extruded by users into various specifications of capacitor shells, hoses and aluminum shells.

ways to produce:

Punch processing: 1. Blank cutting (cutting into square) 2. Blanking~~~~ (punching into the wafer you want)

If it is a coil, add an uncoil in front.

Automatic wafer blanking production line processing: The automatic aluminum wafer blanking production line is an integrated production line from coil uncoiling, strip leveling, wafer blanking, finished product palletizing, and scrap shearing. The production line is widely used in all kinds of aluminum wafer industries, such as cookware wafers, lamp wafers, tank heads, etc., in the aluminum processing manufacturing industry, and has met the large number of wafer blank production needs of enterprises. This production line automatically selects the most suitable layout method according to the width of the coil and the diameter of the wafer, and directly performs blanking processing and production on the entire strip, so that the raw material utilization rate can reach more than 80%, which is far better than other wafer blanking Method, save a lot of production costs for enterprise production.

The main components of the production line are: decoiler, leveling machine, feeder, swing unit, special closed single-point mechanical press, palletizing device, scrap shearing device, hydraulic system, electrical control system, etc.

Technical characteristics of the production line:

1. It is fully automatic with numerical control. This production line starts from the unwinding of the coil until the complete blanking of the whole material. There is no need for manual contact with any materials and no adjustments. This fundamentally eliminates the hidden dangers and products of ordinary punching. Hidden quality hazards.

2. The line can directly produce wafers from the coil, without the need for slitting and cross-cutting of the coil, which reduces the production process, reduces the production cost, and reduces the possibility of damaging the surface of the coil.

3. This line makes full use of the width of the coil and adopts high-precision servo motor drive system control to minimize the distance between the wafers and the distance from the wafer to the material edge, radically reduce the amount of waste, and make the raw material utilization rate reach 80% above.

4. The production speed can reach 40-55 pieces per minute, which improves the production efficiency.

5. Due to the modular mold design, when converting wafer production specifications, the conversion time can be reduced to less than 15 minutes. The diameter of the discs that can be produced ranges from 85 mm to 750 mm.

6. The uncoiling system, six-fold leveling machine, high-rigidity mechanical press, automatic palletizing system, etc., ensure the high quality of wafer products.